Search found 294 matches
- 09 Nov 2011, 14:57
- Forum: Development
- Topic: Accessing u-boot variables from linux
- Replies: 21
- Views: 31895
Does anyone know how to get this to work on the bubba two ? I just managed to make my bubba boot on a raid-1 device, and I would like to write an howto about it ; However it requires a change in the u-boot environment, and it would be nice to avoid the serial cable prerequisite :wink: . So far I ins...
- 08 Nov 2011, 08:32
- Forum: B2 & B3 Support
- Topic: B2 won't accept DHCP Offer in rescue mode
- Replies: 18
- Views: 16074
So I started trying to diagnose this issue with my brand new serial console access :P. Here is my test environment : - A Bubba 2 with the 2.4RC1 image on a FAT32 usb disk, DO_INSTALL=0 in bubba.cfg - A laptop with debian squeeze with static IP adress 192.168.1.1/24 on eth0, without firewall - busybo...
After a contact with FTDI, they suggested a very simple test I didn't think about : contact the TX and the RX wires together on the cable, open a console and see if sent characters echo back. Which didn't work so I sent back the cable for an exchange. I shall keep you posted when I'll receive the ne...
I'm tryning to get my console to work, but I have difficulties. I bought a FTDI USB-TTL converter as advised on the wiki (TTL-232RG-VREG3V3-WE) and had it soldered on my motherboard as described in the previous post. Then plugged in my computer and started minicom. The COM parameters are 115200 8bit...
- 07 Oct 2011, 06:27
- Forum: My Bubba
- Topic: Running Debian lenny or squeeze on Bubba Two
- Replies: 63
- Views: 77653
Hello, I've started to play with the 2.3E image, to see wether it may solve my printing issue on 2.0. So far so good, it still prints after a reboot, which is quite an achievement, we'll see in the long run ! However would it be possible to release also the kernel sources for this version (or at lea...